How do i adjust metal bi fold doors at top and bottom? - adjust bi-fold clo
You have to adapt, usually a screw in the trough assembly to the height. Take the small key or a pair of pliers.
Sunday, January 31, 2010
Adjust Bi-fold Clo How Do I Adjust Metal Bi Fold Doors At Top And Bottom?
Subscribe to:
Post Comments (Atom)
It depends on the mechanism. I have wooden doors, leaflets in front of a Laundromat. Above the door, which is closest to the door jamb, there is a pin that fits in a sliding support with a hole in the rail. This attitude has a screw in, so you can loosen the screws that push the medium in which you want to align the top of the door, and then pull out to block him.
ReplyDeleteIn the lower part of the door is a threaded rod that has an asterisk in the search for his head. Here, in a metal bracket on the floor with a jagged jump. Simply lift the door and put his head into the slot machines asterisks to approximate the bottom of the door. You can also increase the threaded rod, or reduce the height of the door.
This can be fun ... hehehe
ReplyDeleteOk, a couple of ways of adapting to a metal or a different door diptychs.
The first is the light - this is done by adjusting the screw on the top and bottom, which rotates around to the door. Tighten the lower screw to increase at the door, etc. will be twice the cons nuts. These help to "lock" the bolt in place.
Second adjustment to the door of the "square" with the opening. If you look inside the running rail when the door is mounted on the outer edge, you will be a clip that holds the lock on the top of the door. This clip is usually kept by one or two screws. Loosen Up, and the assembly can slide left or right on the right track. The bottom screw is a similar picture. So that you can open the next door or above the mantel, even, if necessary, the angle a bit.
If you are on top of the bag is actually slides back and forth to come, you will find that the pin is spring. You can press the spindle, and door edgeRunway. This makes it much easier than other clips and pins that receive the door panel made.
Well .. That all this assumes the question is undamaged and in very good condition, etc. If damage is the length, you can get a kit of equipment in your local hardware store or building materials.
http://www.ehow.com/how_15289_maintain-b ...
http://www.diynetwork.com/diy/dr_repair/ ...
This link has the best picture clips that hold the stylus in position - http://www.rd.com/familyhandyman/content ...
Have Fun