How do i program a factory gm door remote control for a 2004 chevy silverado truck? - program gm remote
You need it to be a dealer in 2004, not possible without a rescheduling Scan Tool
Sunday, January 17, 2010
Program Gm Remote How Do I Program A Factory Gm Door Remote Control For A 2004 Chevy Silverado Truck?
Subscribe to:
Post Comments (Atom)
1. Close all doors of the vehicles.
ReplyDelete2. Insert the key in the ignition.
3. Hold down the power UNLOCK button still holding the driver door panel
until it is released in step 9.
4. Follow steps 5 to 8, the relatively rapid succession.
5. Turn the ignition switch to the ON position (as you can go, without the
Engine).
6. Turn the ignition key to the OFF position.
7. Turn the ignition key to the ON position.
8. Turn the ignition key to the OFF position.
9. Release the unlock button on the power panel door. The vehicle locking and unlocking
Doors automatically.
10. Press and hold the lock and unlock the transmitter simultaneously until
Locks and opens the door.
This step may take up to 30 seconds.
11. Repeat step 10 for each additional transmitter (including existing
forwardters).
12. Turn the ignition switch to the ON position on the programming of the channel exit
Fashion.
The draft law is that the remote control of silverado.The 2004 Poster Program, which says you need a scan tool is eather NOWS something really stupid or trucks.Best Chevrolet luck.
closed doors, the key for the IGN. not pos. Hold the lock switch to unlock the door and turn off the key on the engine twice, then the unlock option, then press and hold the lock and unlock the remote lock and unlock after 30 seconds, then turn the key contact. the fact
ReplyDeleteclosed doors, the key for the IGN. not pos. Hold the lock switch to unlock the door and turn off the key on the engine twice, then the unlock option, then press and hold the lock and unlock the remote lock and unlock after 30 seconds, then turn the key contact. the fact
ReplyDelete